Netgear extender fails to locate the existing router name? Fix it now

When you complete WiFi range extender setup, you get an amplified range and coverage throughout the home or office. But sometimes, the extender may produce an issue of not recognizing the existing router name. It is truly frustrating as it doesn’t go away regardless of what you try. However, fret not. We have discovered some possible workarounds to this issue. Continue reading.

Solution 1: Make sure the extender is set up properly                           

If you are experiencing dead zones in your home or office, you have definitely installed a Netgear WiFi range extender. It receives the signals coming from your WiFi router or access point and then retransmits them all over the house or workplace. With Netgear extenders, the black zones turn into white meaning that you can now access the high-speed internet in such areas as well.

But if your Netgear extender fails  mto find the existing router name, it may happen that you may not set it up accurately. There are two main ways to set up the extender: using mywifiext and WPS method. Go through our Netgear new extender setup mentioned below:

Netgear go extender setup utilizing mywifiext

www.Mywifiext.net is the default web deliver given by Netgear to make the WiFi go extender setup much less demanding. Pursue the means offered beneath to introduce and arrange the extender utilizing the web address:

Put the extender to a clean and clean place.

Also, where you put the extender must be free from an obstruction making articles, for example, microwaves, child screens, remote speakers, cordless telephones, and so forth.

Turn on the range extender by connecting it to a power attachment.

Take any shrewd contraption and associate it to a quick web association.

Open your most loved internet browser and go to mywifiext.net setup page.

It will open a Netgear genie setup wizard.

Enter the security settings for your system.

Select the system to expand.

Finally, tap on proceed with catch.

Great job! Your range extender has now set up totally. Associate all your brilliant gadgets to the all-inclusive system and appreciate a continuous web association.

Netgear WiFi go extender setup utilizing WPS

WPS represents WiFi Protected Setup. It is the most straightforward approach to set up and introduce your Netgear remote range extender. Simply press the WPS catch given on the extender. In any case, ensure that the extender is running the most recent firmware form on it. Additionally, a steady power supply must be connected to the WiFi sponsor so you can set it up with no issue.

Solution 2: Change the switch channel

Netgear extender neglects to locate the current switch name when the switch is determined to DNS i.e. Dynamic Frequency Selection channel. Because of this channel, there are chances that it isn’t obvious in the all-encompassing system channels’ rundown. Stroll through the guidelines gave underneath to dispose of this issue:

You should initially put your extender and switch precisely. A while later, you can proceed with the WiFi run extender setup process.

Launch an internet browser on a savvy gadget like a PC or PC.

Type 192.168.1.250 IP address as web URL and hit enter key.

Navigate to the data transmission and recurrence segment.

Change the channel choice to auto or DFS channel.

Now the channel of your router has been changed to a non-DFS channel. So recheck the network list. It should contain the existing router name in the list. Just select the network and connect to it with ease.

Solution-3: Opt for instant technical support

If you are still having the same issue even after following the aforementioned methods, contact our technical support executives immediately. We have our experts’ team available round the clock to provide support for Netgear WiFi range extenders and routers. You can get in touch with our expert technicians via a phone call, email or through online chat.

Leave a Reply

Your email address will not be published. Required fields are marked *